Home Resources 3D Printer Downloads

3D Printer Downloads

Click the pic & go to Makerbot’s download site.

LockLab-Tray

This is the “Official” LockLab pinning tray.  The design is about 8″ x 6″, but you can scale it whatever size you like.  It takes about six hours to print.

Tray-with-Slot

This modified version is to accommodate the plug in the V-slot.  It also has separate chambers for the pins, springs, wafers and tweezers along the top.  It takes about five hours to print.

Mini-tray

The mini tray is small enough to fit into your pocket, yet has everything you need to field strip and re-pin a lock.  It measures about 3 x 3 and is thinner than the other trays, so takes only about two hours to print.

BB-Handle-2

If you make your picks out of windshield wiper inserts, this is the handle for you.  The measure measurements are the same as Peterson picks and it has a slot in the front for the wiper insert.  I usually print off 10-12 at a time and epoxy in the insert, then grind the pick.  The handle gives me something to hold on to when grinding and sanding on the insert.

Followers

This is a print platform working on 14 complete sets of 4 followers. The four fit the most common diameters in N. America and Europe and have different ends to accommodate different actuators.  A set of 4 takes only about 75 minutes to print.

Dremel-Tool-Org-2

I got tired of having all my expensive dremel bits rattling around in my tool box, so designed this neat little carrier to hold them.  Now I know where everything is, it’s condition, and my inventory level.  Never again will I run short of bits or cutting disks!

Facebook Auto Publish Powered By : XYZScripts.com